Motorola MVME162P-244 Series, Installation And Use Manual

Page: 29 / 146

Preparing the Board
http://www.motorola.com/computer/literature 1-11
1
Installation of New SIM
1. Observe the orientation of the connector keys on SIM connector J1
and MVME162P4 connector J15. Turn the SIM so that the keys line
up and place it gently on connector J15, aligning the mounting
hole(s) at the SIM corners (or center) with the matching standoff(s)
on the MVME162P4.
2. Gently press the top of the SIM to seat it on the connector. If the
SIM does not seat with gentle pressure, recheck the orientation. If
the SIM connector is oriented incorrectly, the mounting hole(s) will
not line up with the standoff(s).
!
Caution
Do not attempt to force the SIM into place if it is oriented incorrectly.
3. Place the one or two 4-40 x
3
/
16
” Phillips-head screw(s) that you
previously removed (or that were supplied with the new SIM) into
the one center or two opposite-corner mounting hole(s). Turn the
screw(s) into the standoff(s) but do not overtighten.
The signal relationships and signal connections in the various serial
configurations available for ports A and B are illustrated in Figures 1-3
through 1-6.