Motorola MTM800 FuG ET, Installation Manual

Page: 105 / 268

Figure 66: Ethernet Control Head – Rear Connectors
10 9 8 7 6 5 4 3 2 1
1 2 3 4 5 6 7 8 9 10 11 12 13
14 15 16 17 18 19 20 21 22 23 24 25
1
2
Number Description
1 10-Pin Ethernet Connector
2 25-Pin Back Connector
Table 60: 10-Pin Ethernet Connector
Pin Function Description
1 FLT_A+ (12 V) This is the voltage supply for the Control Head from power sup-
ply or battery
2 TX+ Ethernet Ethernet transmit positive line, TX+
3 TX– Ethernet Ethernet transmit negative line, TX-
4 RX+ Ethernet Ethernet receive positive line, RX+
5 GND Main board GND
6 GND Main board GND
7 RX- Ethernet Ethernet receive negative line, RX-
8 CH_ON_OFF_OUT1_5V ON/OFF control line from Transceiver to Control Head
9 CH_ON_OFF_IN1_5V ON/OFF control line from Control Head to Transceiver
10 FLT_A+ (12 V) The voltage supply for the Control Head from power supply or
battery
Table 61: 25-Pin Back Connector
Pin Function Description
1 GPIO_9 Output: Active for duration of call (car radio mute)
2 GPIO_6 External PTT for MIC_HF1,
Ethernet Control Head GPIO6
3 GPIO_8 Control Head GPIO2 (CPS configurable)
Table continued…
68015000553-KC
Chapter 5: Connectors and PIN Assignment
Send Feedback 105