Motorola MT2070, User Manual

Page: 169 / 606

Radio Communications 4 - 3
Wireless Beeper Definitions
When the device scans the pairing bar code it issues various beep sequences indicating successful or
unsuccessful operations. See
Table 4-2 for beep sequences that occur during pairing operations.
Table 4-2
Wireless Beeper Definitions
Beeper Sequence Indication
Short low-high beeps Device has paired with the cradle.
Short high-low beeps Device has unpaired with the cradle.
Note: When connected to a remote device using SPP or HID, if a
disconnect beep sequence sounds immediately after scanning a bar
code, check the host device to determine if it received the transmitted
data. The device may have transmitted the last bar code scanned after
losing the connection.
Long low-long high beeps Unsuccessful pairing attempt. See Auto-reconnect Feature on page
4-14 .
Long low-long high-long low-long high beeps Remote device rejected connection attempt, possibly due to an attempt
to pair with a cradle that is already paired with the maximum number of
devices.
Four long low beeps 1. A transmission error was detected in a scanned symbol. The data is
ignored. This occurs if a unit is not properly configured. Check option
setting.
2. When communicating with a cradle, the cradle acknowledges
receipt of data. If the acknowledgment is not received, this transmission
error beep sequence sounds. Data may still have been received by the
host. Check the host system for receipt of transmitted data. If data was
not received by the host, re-scan the bar code.
Five high beeps Emitted every 5 seconds while a reconnect attempt is in progress. See
Auto-reconnect Feature on page 4-14 .