Motorola MCPN750A, Installation And Use Manual

Page: 24 / 188

Getting Started
http://www.motorola.com/computer/literature 1-3
1
Getting Started
This section provides an overview of the steps necessary to install and
power up the MCPN750A, any additional equipment requirements, and a
brief section on unpacking and ESD precautions. As identified in the table
below, several steps can be omitted if your board, for example, has been
shipped with PMCs and Flash already installed
Overview of Start-up Procedure
The following table lists the things you will need to do before you can use
this board and tells where to find the information you need to perform each
step. Be sure to read this entire chapter, including all Caution and Warning
notes, before you begin.
Table 1-1. Startup Overview
Task Section or Manual Reference Page
Unpack the hardware. Unpacking Instructions 1-5
Configure the hardware by
setting jumpers on the baseboard
and transition module. MCPN750A Baseboard Preparation and
TMCPN710 or TM-PIMC-0001 Transition Module
Preparation 1-6 , 1-11 ,
and 1-16
Ensure CompactFlash card is
installed (if required) Compact Flash Memory Card Installation 1-6
Install the PMC Module (if
required) PMC Module Installation 1-21
Install the MCPN750A in the
chassis. MCPN750A CompactPCI SBC Installation 1-24
Install the transition module in
the chassis. TMCPN710 or TM-PIMC-0001 Transition Module
Installation 1-26
Connect any other equipment
you will be using. Connector Pin Assignments 7-1
For more information on optional devices and
equipment, refer to the documentation provided with
the equipment.
Power up the system. Applying Power 2-1