Motorola MCPN750A, Installation And Use Manual

Page: 118 / 188

Block Diagram
http://www.motorola.com/computer/literature 6-13
6
❏
Do not disassemble, deform, or apply excessive pressure.
❏
Do not heat or incinerate.
❏
Do not apply solder directly.
❏
Do not use different models, or new and old batteries together.
❏
Do not charge.
❏
Always check proper polarity.
!
Caution
Danger of explosion if battery is replaced incorrectly.
Replace battery only with the same or equivalent type recommended by
the equipment manufacturer. Dispose of used batteries according to local
regulations and manufacturer’s instructions.
!
Caution
Avoid touching areas of integrated circuitry; static discharge
can damage circuits.
Use ESD
Wrist Strap
Attach an ESD strap to your wrist. Attach the other end of the ESD strap
to an electrical ground. (Note that the system chassis may not be
gro8unded if it is unplugged.) The ESD strap must be secured to your wrist
and to ground throughout the procedure.
1. To remove the battery from the module, carefully pull the battery
from the socket.
2. Before installing a new battery, ensure that the battery pins are
clean.
3. Note the battery polarity and press the new battery into the socket.
Note
When the battery is in the socket, no soldering is required.
4. Recycle or dispose of the old battery according to local regulations
and manufacturer’s instructions.