Motorola i860, Field Service Manual, Page: 33 / 106

DISPLAYS, MESSAGES, AND ALERTS: Using the Optional Vibrate Function
3-6
68P80400P73- A
3.5 Using the Optional Vibrate Function
The vibrate function (VibraCall) notifies the user of incoming phone or dispatch calls, DC/GC calls,
messages, notifications, and call alerts.
If the unit is set for Vibrate in any mode, it will vibrate for 1/2 sec during the power-up sequence.
To set unit to vibrate for all calls:
1. Using the keypad, press the Menu key
m
.
2. Scroll to
Ring Tones
, and then press
O
.
3. Scroll to Vibrate All , and then press
O
.
4. Scroll left or right to set
Vibrate All
on or off.
5. After you select a Vibrate mode, the unit vibrates for 1/2 sec while exiting the menu.
The following table describes the cadence for each vibrator mode:
Self-Test Fail Spkr Spkr 900Hz 1x500ms on Self test fails on power up
Speaker Volume Set Spkr Spkr 1000Hz Continuous Volume changed on quiet
channel or in Programming
Menu
System Busy Ear Spkr 480/
620Hz 4x(0.25s on+0.25s off) 480Hz; 4x
(0.25s on+ 0.25s off) 620Hz All channels are busy
Talk Permit Ear Spkr 1800Hz 2x (24ms on+24ms off) + 48ms on PTT transmission accepted
Talk Prohibit Ear Spkr 900Hz Continuous PTT transmission not allowed
TOT Warning Ear Spkr 900Hz 1x80ms on Transmission rights expiring
Valid Key Press Ear Ear 1800Hz 1x80ms on Valid key pressed or unit
powered up
Voice Mail
Received in Idle Spkr Spkr 2400/
2743Hz 8x(64ms on 64ms on
2743Hz) every 30 seconds Voice mail received while unit is
idle
Voice Mail
Received in
Interconnect Ear Ear 2400/
2743Hz 8x(64ms on 64ms on
2743Hz) every 30 seconds Voice mail received while unit is
in interconnect mode
Table 3-5. Vibrator Settings
Mode Cadence
Vibrate All or Selectable Vibrate 2x(500ms on, 500ms off) + 500ms on + 2.5 sec. off
Ring Tones Three Vibrate Only cadences, followed by an audible ring tone
until answered or party hangs up
Off Turns off the vibrator function
Table 3-4. Alert Tones (Continued)
Tone Low High Freq Cadence When Tone Occurs