HDD200 Decoder
HDD200 User Guide
11
Installation Instructions
Included with your HDD200 are the following components:
- 1 ea. HDD200 high definition decoder
- 1 ea. User Guide and 1 ea. warranty card
- 1 ea. 1/8" mini-stereo phone cable for use with the Motorola BCS digital
cable terminal (DCT2000)
- 1 ea. 1/8" mini-stereo phone to DB-9 (9-pin HSI connector) for use with
Motorola BCS digital satellite receiver DSR400 series satellite receivers
Installation
To install your HDD200 to your digital satellite receiver (either series) use the 9-
pin HSI connector.
1. Connect the 9-pin side of the HSI connector to the MMAP port (Multi
Media Access Port) on your satellite receiver.
2. Connect the 1/8" stereo phone side of the HSI connector to the
HDD200 using the High Speed digital satellite receiver via the
corresponding colored connectors on the HDD200. There is an
optional S-Video port (N/A on the DSR410 series) that can be used for
analog video passthrough, instead of using the RCA connectors.
3. To connect audio outputs, you need a second set of RCA cables. Use
this set to connect the second row of audio outputs on your HDD200
to the corresponding ports on your television set or stereo.
4. Using either the RGB/HV ports (with a red/green/blue/yellow/white
cable) or the YP
B
P
R
ports on the back of your HDTV. The HDD200
has both RGB/HV and YP
B
P
R
connectors to work with various
different HDTV’s. Use the button on the rear panel of the HDD200 to
select the output.
5. Once you have made all of your audio and video connections to the
HDD200, the digital satellite receiver, the HDTV and stereo, plug in
your HDD200.
6. Turn the power on for all connected components; satellite receiver,
HDD200, HDTV and stereo (if connected).
7. Since HDTV’s have different output formats, use the switch on the
back of the HDD200 to adjust the output to your specific HDTV’s
format. The HDD200 supports
480p, 720p, 1080i, or native
mode
formats.
