1-6
68P02945C75-A
June 1999
Radio Disassembly/Assembly
GTX/GTX LTR/LTS 2000 Portable Radios Service Manual
Radio Reassembly
NOTE
The gasket helps keep the radio free from
unwanted dirt, dust, and water. We rec-
ommend using a
new
lubricated gasket
(part no. 3280545C01) when reassem-
bling the radio. Using an old gasket
could impair the overall seal quality of
the radio.
2.
Insert assembled chassis, main board, and
front shield into radio housing at
approximately a 45-degree angle (Figure 1-16).
Exercise caution while inserting the volume
and frequency controls through the housing
top.
IMPORTANT
The main board must be inserted into
chassis (Step 3) before you can secure
chassis into radio housing.
3.
Connect microphone/speaker ribbon cable.
4.
While pressing chassis toward the housing
top, press the bottom end down into the
housing until the bottom housing wall snaps
over the chassis retaining studs.
NOTE
The chassis should snap Þrmly into place
and the ßexible circuit should be placed
nicely
inside
the radio.
5.
Replace the knobs, antenna and battery.
Figure 1-16.
Insert Chassis into Housing
Make certain that the
flexible circuit is completely
inside the housing.