1-10
INSTALLATION
5.1.3
To Remove the Radio / Remote Mount from the Frame
1.
Push the two demounting tools (see Figure 1-6 Mounting the Radio into the Dashboard)
through the openings in the frame until the two springs release the radio.
2.
Slide out the radio.
5.2
External Speaker Installation
1.
Remove the speaker from the trunnion bracket by loosening the two wing screws.
2.
Choose a place to mount the speaker.
3.
Use the trunnion bracket as a template to mark the locations of the three mounting holes.
4.
Centerpunch and drill a 4 mm (5/32-inch) diameter hole at each location.
5.
Mount the trunnion bracket with the screws supplied. (See Figure 1-7 Mounting the Speaker
Under the Dashboard.)
6.
Insert the speaker into the trunnion bracket and tighten the two wing screws.
7.
Insert the external speaker accessory plug into the accessory connector of the radio.
NOTE
1. The fixing tabs should be checked for tightness each time the radio is
removed. The tabs are easily tightened by twisting a large flat-bladed
screwdriver in the slot behind the tabs.
2. The frame is not designed for daily mounting and demounting.
Figure 1-7 Mounting the Speaker Under the Dashboard
Dashboard
Firewall
Trunnion Bracket
To
Firewall
Mounting
or
Dashboard
Firewall
10-16 x 5/8''
Self-Tapping
Screw
0.157'' (0.399cm)
Diameter
Trunnion
Bracket
Console or Floor
FL0830253-O
