Motorola DSR-470, User Manual

Page: 13 / 88

Regulatory Information
DSR470 User Guide 13
FCC Part 68
This equipment complies with Part 68 of the FCC rules. Located on
the equipment is a label that contains, among other information, the
FCC registration number and Ringer Equivalence Number (REN).
If requested, this information must be provided to the telephone
company.
The REN is used to determine the quantity of devices which may
be connected to the telephone line. Excessive REN’s on the
telephone line may result in the devices not ringing in response to
an incoming call. In most, but not all areas, the sum of the REN’s
should not exceed five (5.0). To be certain of the number of devices
that may be connected to the line, as determined by the total REN’s
contact the telephone company to determine the maximum REN
for the calling area.
This equipment cannot be used on the telephone company-
provided coin service. Connection to party line service is subject to
state tariffs.
If this equipment causes harm to the telephone network, the
telephone company will notify you in advance that temporary
discontinuance of service may be required. If advance notice isn’t
practical, the telephone company will notify you as soon as
possible. Also you will be advised of your right to file a complaint
with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities,
equipment, operations, or procedures that could affect the
operation of the equipment. If this happens, the telephone company
will provide advance notice in order for you to make the necessary
modifications in order to maintain uninterrupted service.
If trouble is experienced with this equipment, please contact:
Motorola Broadband Communications Sector
6450 Sequence Dr., San Diego, CA 92121
1-888-436-4678
If the trouble is causing harm to the telephone network, the
telephone company may request you to remove the equipment from
the network until the problem is resolved.
This equipment uses the following USOC jacks: RJ11C
It is recommended that the customer install an AC surge arrester in
the AC outlet to which this device is connected. This is to avoid
damaging the equipment caused by local lightening strikes and
other electrical surges.