Motorola DIMETRA MTS 2, Installation, Configuration And Basic Service Manual

Page: 79 / 517

MTS 2 and MTS 4 Installation, Con
fi
guration and Basic Service Manual Pre-Installation Checklist
•
Check for loose or damaged equipment
•
Check all sides of the cabinet for dents, scratches, or other damage
•
Check all cabinet wiring to ensure connections are in place
•
Check modules and boards for physical damage to controls or connectors
•
Verify that ground straps are secure
If any equipment is damaged, contact the shipping company immediately, and
then your Motorola representative.
Pre-Installation Checklist
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■
■
Proper installation ensures the best possible performance and reliability of the MTS station.
Preinstallation planning is required. This includes considering the mounting location of the cabinet
in relation to input power, antennas, and telephone interfaces. Also, consider the site environment
conditions, the particular mounting method, and required tools and equipment.
The installation shall only be carried out after the following activities are completed:
•
Antenna installation (including GPS antenna)
•
New building earth (if required)
•
The installation of the X.21 or E1 link (to the control centre) by the telephone line service provider
•
The installation of the cable tray in the equipment room
•
The increase in the capacity of the mains power supply (if required)
•
The increase in the capacity of the stand-by mains power supply (if required)
•
The completion of any civil works on the site (for example, new or modi
fi
ed
accommodation, new access road, and so on)
•
The position in which each piece of equipment will be placed on the
fl
oor
has been marked and agreed
•
Reinforcement of site
fl
oor to accommodate load of site equipment (if required)
•
All the equipment has been delivered to site and placed in their
fi
nal positions
by the transportation company
Proper surge protection should be installed on E1/X.21 site links, all antennas, and
power inputs to prevent potential damage to the MTS.
For full instructions and guidelines, please always refer to
Motorola Standards and
Guidelines for Communications Sites, R56
manual .
6802800U74-N September 2009
4-3