Motorola DCX3200 P2, Installation Manual

Page: 18 / 77

3 INSTALLATION
10
1. Determine if you are connecting the audio to a home theater receiver or directly to
the TV:
•
For an HDMI™ or IEEE-1394 video connection, no additional audio connections
to the TV are required.
•
If the receiver or TV has a digital audio (S/PDIF) input, use the digital audio
OPTICAL (S/PDIF)
or
COAXIAL (S/PDIF)
outputs.
•
Otherwise, use the baseband left and right audio outputs.
2. Locate the cabling diagram(s) that best match the subscriber’s configuration.
3. Connect the audio and video cables in a manner matching that diagram.
4. Determine if you are connecting to a data device (see Data Device Connections in
this section). For installation details, refer to the instructions included with the data
device.
5. Connect the cable terminal to the coaxial cable wall outlet.
6. Perform the operational check for the remote control.
7. Optimize the High-Definition settings.
Connecting HDTV — Single Connection for Video/Audio
Cable-In
Connect an RF coaxial cable to the cable wall outlet and the
CABLE IN
connector on the
DCX set-top.
HDMI
If the TV has an HDMI™ input, this is for both audio and video if you are using the TV
speakers. Connect a Standard HDMI™ cable to the TV and to the HDMI™ connect on
the DCX set-top.
IEEE-1394
If the HDTV has an IEEE-1394 connector, you can use the IEEE-1394 for both the video
and audio connection:
•
Connect an IEEE-1394 cable to the IEEE-1394 connector on the HDTV and DCX set-
top.
Note: On-screen graphics will not be displayed when you are using the IEEE-1394
connection on the rear panel of the DCX set-top.
If there is an audio/video receiver and you are not using the TV’s speakers, go to
Connecting the DCX Set-top to an A/V Receiver — Audio .