Using additional handsets
17
NOTE
If only one handset is registered the display prompts "Not
available" and returns to the previous screen. You must register
additional handsets before the handsets will be displayed and
make Internal calls.
NOTE
If the Room Monitor is triggered to call a handset or number and
the called handset is on a call, an alert tone of 3 beeps will be
heard. If the Room Monitor is triggered continuously the alert
beap will be emiitted every 5 seconds.
WARNING
This product is not intended for use as a baby safety device and
is not a substitute for adult supervision.
12. Using additional handsets
You can use up to five D11P additional handsets with your
D11P base to extend your phone system without needing to
install extension sockets for each new phone.
Your D11P handset can also be registered to up to 3 other
bases. You can then select the base you would prefer to use.
If you have purchased a D11P multiple pack any additional
handsets come pre-registered to the base.
If you have purchased an additional handset separately you
must register it to your D11P base before it can be used.
Registering an additional handset
At the base:
1.
Press and hold
p
for 2 seconds until the base Power
starts flashing. The base will remain in registration mode for
90 seconds.
At the handset:
1.
If the handset is new and the display shows
Please Register
.
Press
Menu
. Scroll
u
to
Registration
. Press
Select
.
Or
If the handset has already been registered to another base
the standby display is shown. Press
Menu
, scroll
u
or
d
to
Registration
and press
Select
.
2.
Register Handset
is highlighted. Press
Select
.
3.
Bases are displayed. If necessary, scroll
u
or
d
to a new
base you wish to register your D11P handset to and press
Select
.
4.
Enter the system PIN and press
OK
. (Default setting =
0000)
5.
The display shows
Searching Base X
(where X is the chosen
base number) then
Handset Registered
.
The handset is automatically assigned the next available
handset number.
If registration is not successful first time, please repeat the
process again in case the base registration period ran out of
time.
If there are already 5 handsets registered to the base, the
registration will fail. You must de-register another handset before
you can register the new one.
Select a base
If your D11P handset is registered to more than one base, you
can select which base to use.
1.
Press
Menu
, scroll
u
or
d
to
Registration
and press
Select
.
2.
Scroll
d
to
Select Base
and press
Select
.
3.
All base numbers are displayed.
(In use)
is added to bases
where the handset was previously registered to. Scroll
u
or
d
to the base you want and press
Select
.
4.
Display shows
Searching Base…
. then the standby display for
that base.
De-register a handset
Use one handset to de-register another. You cannot de-register
the handset you are using.
1.
Press
Menu
, scroll
u
or
d
to
Registration
and press
Select
.
2.
Scroll
d
to
De-register
and press
Select
.
3.
Enter the system PIN and press
OK
. (Default setting =
0000)
4.
Scroll
u
or
d
to the handset you want to de-register and
press
Select
.
5.
Press
Yes
to confirm or
No
to cancel.
6.
Press
Back
to return to the previous menu level or
>
to
return to standby.
