NOTICE:
Ensure the switch on the cloning cable is set to
Legacy
.
During the cloning process, no power is applied to the SUC. The batteries cannot be
charged. A data communication is established between the two radios.
3
Turn on the target radio and place it into one of the SUC.
4
To power the source radio, press and hold the
PTT
button and the
-
button simultaneously while
turning on the radio until you hear the cloning tone.
5
To start the cloning process, place the source radio in its SUC with an audio accessory, then
press and release the
Menu
button.
If successful, the source radio sounds a good key chirp tone.
If unsuccessful, the source radio sounds bonk tone.
The tone sounds for no more than five seconds.
6
Turn the radios off and on to bring the radios to the user mode by exiting the clone mode when
the cloning process is completed.
NOTICE:
When the radio is in clone mode, the
Auto Power Off
feature is not applicable.
5.3
Cloning Radios using the Multi-Unit Charger
Prerequisites:
• A fully charged battery on each radio.
• CLP Series Multi-Unit Charger (MUC).
• Both radios are turned off.
• Source radio: Radio to be cloned.
• Target radio: Radio to which the configuration of the source radio is to be copied.
Procedure:
1
To put the source radio into clone mode, press and hold the source radio
PTT
button and the
-
button simultaneously while turning on the radio until you hear the cloning tone.
2
Place the source radio into one of the charging pockets that has the
CLONE
label.
3
Turn on the target radio and place it in the pairing charging pocket that has the
CLONE
label
and start the cloning process.
4
To start the cloning process, press the
Menu
button on the source radio.
The source radio generates the start clone tone.
5
To activate the radio, turn off and on the radios when cloning process is completed.
6
To clone another radio, repeat
to
7
To exit clone mode on the source radio, turn off the radio.
MN007419A01-AA
Chapter 5: Radio Cloning
32
