Motorola CDR500, Programming Manual

Page: 72 / 104

9-2
6864110R66-O March, 2001
Programming the Professional Series Radios for use with a ZR310 Repeater Controller CDR500 & CDR700 Repeater Service Manual
Programming
8. “Close” the “Radio Configuration” window.
9. Click the + indicator next to “Conventional
Personality” selection from the opening CPS
“Tree View” window.
10. Double click the “Conventional Personality -
1” selection.
11. Select the “Basic” tab.
12. If the radio is a display model (LCD front
panel), you may enter an “Alias” such as
“Repeater RX”.
13. Select a “Channel Bandwidth (kHz):” as
defined by the radio licensing authority. You
have the choice of 12.5, 20 or 25 kHz. (Typical
bandwidths in the United States are 12.5 and
25 kHz for VHF Highband and UHF, and 20
kHz for Lowband.)
14. Enter the receive frequency for the repeater in
the “Rx” area at “Frequency (MHz)”.
15. Select the “Squelch Type:” as “CSQ” (Carrier
SQuelch).
16. Check the “Rx Only Personality” box. Your
screen should appear similar to Figure 9-3.
17. Enter any other special programming require-
ments in the appropriate windows.
18. Assign the personality to a zone in the “Person-
ality Assignment to Zone” selection windows.
19. Program the receive radio.
Transmit Radio Programming
1. Read the Professional Series transmit radio.
2. After the radio is read, select “Radio Configu-
ration” from the opening CPS “Tree View”
window.
3. Click the “Accessory Configuration” tab.
4. Click the “Ext. PTT Audio” dropdown arrow
button. Select “Ext Mic & Flat TX”.
5. Click the “Ignition Sense Type:” dropdown
arrow button. Select “On/Off & Ignition”.
Your
screen should appear similar to
Figure 9-4.
6. Click the “Accessory Pins” tab.
7. Click the “Accessory Package” dropdown
arrow button. Select “Community RPTR
(ZR310) Tx”. Verify pin 3 is defined as “Exter-
nal Mic PTT (Input)”, Active Level “Low” and
pin 4 is defined as “CSQ Detect (Output)”,
Active Level “High”. Your screen should
appear similar to Figure 9-5.
8. “Close” the “Radio Configuration” window.
9. Click the + indicator next to “Conventional
Personality” selection from the opening CPS
“Tree View” window.
10. Double click the “Conventional Personality -
1” selection.
11. Select the “Basic” tab.
Figure 9-3. Conventional Personality, Basic,
Receive Radio
Figure 9-4. Radio Configuration,
Accessory Configuration, Transmit Radio