INSTALLATION
PREPARATION
Tools required
•
Ethernet crimper
•
Philips screwdriver
•
7/16” nut driver
PROCEDURE
Perform the following steps to install the Canopy 300 SS.
1. Remove the Canopy Surge Suppressor cover by removing the screw located on the front of the
unit.
2. Mount the Surge Suppressor to a surface outside of the premise using the two (2) mounting holes
shown in FIGURE 1.
3. Connect an Ethernet cable, between the power adapter Ethernet socket (pig tail) and either end
of the RJ45 sockets on the Canopy Surge Suppressor.
4. Connect an Ethernet cable, between the other RJ45 socket on the Canopy Suppressor and the
RJ45 socket on the Canopy product.
5. Connect ground wire by wrapping it around the ground post and tightening the locking nut. The
ground wire should be made of heavy gauge (AWG10) copper wire. Consult National Electrical
Code (NEC) and local electrical code for requirements on connection to grounding system.
6. Replace the Canopy Surge Suppressor cover.
Page 6
