Figure 20: Configuring the Camera Aim Setting
NOTICE:
Tapping
Aim Mode
wakes up the camera and places it into aim mode. Images
continue to populate for two minutes at a rate of approximately six seconds between
each image.
4.3
Adjusting the Aiming Point
Procedure:
1
Loosen the ball lock on the Security Enclosure to adjust the camera positioning while watching
the the view of the camera in the application.
2
Adjust the camera until the aiming point is centered on the top of the red line (indicated by the
green arrow), and halfway between the center line (marked 0) and either 0.5 or -0.5 depending
on the camera’s mounting location and the direction of vehicle travel.
Figure 21: Adjusting Camera Aiming Point
NOTICE:
For lanes of travel away from the camera, use (0, 0). For lanes of travel exiting
the left of the image frame, use (0, 0.5). For lanes of travel exiting the right of the image
frame, use (0, -0.5). Allowing the red aim bar to overlap additional lanes of traffic results
in false positives.
MN007598A01-AD
Chapter 4 : Camera Adjustment
23
