APX 8000XE M2
26
Attaching/Removing the Accessory Connector Cover
PREPARING YOUR RADIO FOR USE
The accessory connector is located on the antenna side of the radio. It is used to
connect accessories to the radio.
Note:
To prevent damage to the connector, shield it with the connector cover when
not in use.
Accessory Connector Cover must be fully secured to meet the salt water submersion
specification.
Slide the Accessory Connector Cover over the antenna and position
at the base of the antenna.
Insert the hooked end of the cover into the slot above the connector.
Press downward on the cover’s top to seat it in the slot.
Once in place, tighten by rotating the thumbscrew clockwise by
hand.
To remove the accessory connector cover, rotate the thumbscrew
counterclockwise until it disengages from the radio.
If the thumbscrew is too tight, use an Allen wrench to loosen
it first.
Rotate and lift the connector cover to disengage it from
the radio.
Accessory
Connector
