5A
5B
06
A
A
B
B
05
07
08
04
EN
EN
A
??
mm
B
A -
56mm
PERSA 400
automatism must be installed with a small inclination, to prevent water infiltration
through the extension arm.
For this, the front support must be fixed to the gate with a height lower than the height of the
rear support. See example below:
Example:
• If the height of the rear support (dimension A) is set at 600 mm, then the height of the front
support (dimension B) will be 544 mm (600mm-56mm).
Dimension A
•
Vertical distance from the floor to the top of the rear support.
Dimension B
•
Vertical distance from the floor to the top of the front support.
• Set
dimension A
(this can be any size of your choice).
• After you set
dimension A
, subtract
56mm
to find
dimension B
.
It is very important that these dimensions are respected! Only this way can be assured the
correct functioning and durability of the automatism!
It is also very important that the floor is level to use these dimensions!
VERTICAL INSTALLATION DIMENSIONS
03. AUTOMATISM
TECHNICAL SPECIFICATIONS
LOCK/UNLOCK MOTOR
04. INSTALLATION
Place the unlocking key in the slot signed on
image 05 (motor installed on the left) or 06
(motor installed on the right).
Turn the key to lock or unlock the motor.
PERSA 400
dimensions are the following:
920mm
110mm
122,5mm
