6
200mm
10˚
EN
03. INSTALLATION
INSERT PILLAR INTO THE HOLE
a
) Remove the screws and the pillar cover.
b
) After, insert the pillar into the hole on the ground.
Seal
Remove
seal
APPLY SAND AND CONCRETE
Add sand and then concrete inside the hole to fix the pillar.
FIX THE PILLAR
Remove the material used for the seal and place the cover back on the pillar, fixing with
the same screws that you removed.
COMPACT
SAND
CONCRETE
DRAINAGE
WASTEWATER
CONCRETE
AUTOMATISM INSTALLATION
• At the base of the pillar, place a tube for draining waste water, with a minimum inclination of 10°.
• Provide a tube to pass the electric cable to the control board.
• Place sand around the pillar for better accommodation.
• The concrete must be made with cement and sand, for greater resistance.
• The control board must be installed with a minimum height of 200mm from the ground.
• If the distance between center and pillar is higher than 10 meters, use a cable with Ø2.5mm cross-section.
Apply some cloth paper to seal the inside of the automatismo, preventing dirt or other
object from entering into the automatism.
3a
3b
4
4
5
3
4
5
