6A
6B
D0
D1
OPEN
+12V
GND
NO
COM
NC
MLS4
GND +12V D1 D0
EN
EN
03. INSTALLATION AND CONNECTIONS
04. CONFIGURATION
FACTORY RESET AND SET MANAGEMENT CARD
Connect the two pink wires, then turn on the power. After the sound “didi”, Factory reset is
finished. When indication LED turns green, it means you can set the two admin cards. Read
the first card as admin add card. After that read the second card as admin delete card. Then
LED turns red flash, and after that, the device can work normally.
Note •
Reset factory default won’t delete user cards. If you present the same card on the
second read, the device will whistle 3 consecutive times indicando erro. Then you can
continue present another card. If doesn't happen operations within 10seconds, the device
will enter working mode automatically and the parameter reset to factory default.
Add users by remote control:
ADMIN SETTING ON KEYPAD
Entering admin
operating mode
Press factory default: 999999
Note •
All the below operations need to be under programming
mode.
master code
*
#
Change the master
code
Press
Note •
Master Code length:6~8 digits
Add consecutive
number card
Press
Add consecutive user card numbers, card quantity 1-9999, green
fast flash
Use ID Number to add
user
Press
Note • 1
Card number must be 8 or 10 digits. If the card number
has less than 8 or 10 digits, type 0 before the card number
2
press
#
confirm, press last
#
finish, press
*
exit.
Read card to add user Press
cards quantity
1
#
read card
1
# read card #
8 or 10 digits card number
new code
0
# repeat new code #
card number
1
#
card number
#
WIEGAND READER CONNECTION
Black
Re
d
Whit
e
Gr
een
External reader
