All tests must be performed by qualified personnel due to serious danger
associated with the misuse of electrical systems!
These maintenance measures must be applied every year in order to insure
proper functioning of the automated system.
06
.
COMPONENTS TEST
▷ CAPACITORS CONNECTION SCHEME
MAINTENANCE ◁
07
.
MAINTENANCE
09.A
09.B
▷ Check motor supports
▷ Make sure that supports remain well
fixed on the pillars and gate to ensure
proper functioning of the equipment.
To detect which components have problems on an automated system, sometimes it is
necessary to conduct tests using a direct connection to a 230V AC power supply. For
this it is necessary to merge a 8µF capacitor to make the operator to work.
In the diagram below is shown how this link should be made and how to merge the
different wires of the components.
NOTES:
▷ To perform these tests you don’t need to remove operator from where it is installed,
because this way you can know if connected directly to power supply it will work
correctly.
▷ The order of wiring capacitor to motor wires is not important, as long you connect
one wire to Brown wire of motor and the other one to Black wire of motor;
▷ Common wire should always be connected to power supply.
▷ To reverse motor direction, just replace Black wire with Brown wire of the operator on
the power supply.
▷ With a cloth soaked in lubricant spray,
wipe any residue that accumulates on
the operator’s stainless steel arm.
▷ Apply a small amount of spray
lubricant on the arm and using a dry
cloth remove the excess, leaving a
homogeneous layer of lubricant over
the arm.
▷ Clean stainless steel arm
▷ Lubricate pins
▷ Remove front and rear caps
▷ Place a small amount of lubricant on
the holes that contains support pins.
▷ Install caps on the respective holders.
230V
Power Supply
OPERATOR
LINCE
Capacitor 8µF
Earth wire
Common (Blue)
Black
Brown
