5A
5B
20
m
L
2
3
A
B
EN
EN
SQUARE PLATE BRACKET
04. INSTALLATION AND ADJUSTMENTS
Fix the bracket to the square plate as shown. Fix the square plate to the wall or wall bracket on
the opposite side of the gear.
Install the bearing as shown below.
BEARING INSTALLATION
GEAR BRACKET
Install the gear bracket on the wall or the bracket horizontally.
If the distance is insufficient, the bracket angle must be adjusted (installation angle can be
adjusted between 0° and 44°, make sure the chain stays in the vertical position).
Dimensions for installation (see table).
Model
Distance to centers
Length
Width
AC-6001P/6003P
304 mm
515 mm
300 mm
AC-8001P/8003P
345.5 mm
580 mm
320 mm
AC-10001P/10003P
339 mm
600 mm
360 mm
Placa
Quadrada
Rolamento
Square plate
Join the two Circular Plates I and shaft to the Roll
Join Circular Plates II to the Roll
Bearing
Circular Plate I
Circular Plate II
Gear
Roll
Big gear
Shaft
Bearing
Bracket
Suporte de
Rolamanto
INSTALLING THE MOTOR ON THE LEFT SIDE
It is possible to install the door motor on the left or right side. It is normally delivered on the right
side (seen from the opening side). If you need to switch to the left side, follow the instructions
below.
04. INSTALLATION AND ADJUSTMENTS
01
•
Loosen the 4 screws
1
Parafusos
02
•
Rotate 180 degrees
Parafusos
03
•
Confirm that the chain is in
the vertical position, and retighten
the 4 screws.
Ensure there are no gaps between
the "
A
" sections.
