36 volt battery hook-up
4
Connect black battery lead of power cale to negative (-) post
of battery A. Connect red battery lead of power cable to
positive (+) post of battery C. Connect jumper wire from
positive (+) post of battery A to negative (-) post of battery B.
Connect jumper wire from positive (+) post of battery B to
negative (-) post of battery C. Install 50 amp circuit breaker
in line with positive lead.
TRANSOM MOUNT INSTALLATION
Twist tiller models
1
Clamp screws
– The clamp screws allow for easy motor
removal and installation. Mount your motor on the transom
then tighten the clamp screws securely.
2
Tilt position pin
– The pin allows user to adjust the tilt of the
motor. Push tilt position pin, adjust tilt of motor, and release
pin.
3
Depth adjustment collar
– The depth of the motor can be
adjusted up and down by loosening the depth collar tension
knob located on the column directly above the mount. The
column can be adjusted and motor positioned at the desired
depth by retightening the tension knob.
4
Steering tension adjustment
– To adjust the steering
resistance, simply tighten or loosen the tension knob located
on front of the mount.
5
Quick stow
- Standard on SW models only.
4
GB
When adjusting the tilt on your motor, keep fingers clear
of area between column and bracket.
CAUTION
2
2
4
5
4
3
1
Be sure all switches are in the OFF position before
connecting to batteries. Electrical arching near the
battery could ignite hydrogen gas and cause the battery
to explode.
WARNING
4
g
h
i
k
k
j
l
a
b
c
d
e
f
m
a. Battery A
b. Battery B
c. Battery C
d. Main engine, bilge
pumps, aerators,
accessories
e. Common ground
f. Black battery lead (-)
g. Power cable
h. To foot pedal
(ES models only)
i. To optional sonar display
(PinPoint ready models
only)
j. 50 amp circuit breaker
k. Jumpe wire
l. Red battery lead (+)
m. Jumper wire
90-10235R21 502