Center alignment procedure
Calibrate your straight ahead setting out of heavy wind or
current.
1
Plug battery cable into power source.
2
Make sure your outboard is turned straight and in the water.
3
Lower motor to Run position.
4
To enter setup mode, slowly tilt the rocker pedal until you feel
it click into a detent . This detent position can be found by
tilting pedal all the way toe down, then slowly pushing the
heel of pedal down until you feel pedal click into a detent.
See Figure. (Note: Strong resistance settings of the clutch
nut, makes the detent difficult to feel.)
5
Use Center calibration dial to steer your lower unit to
approximately straight ahead. Set speed wheel at 0.
6
Pick an object directly in front of your boat (a large tree, rock,
dock, etc.). Push and release
the constant button once.
Ramp up your speed wheel,
watching how your boat
moves towards the object.
7
Use Center calibration dial to
steer the motor straight
ahead.
Adjust until your boat moves
straight for at least 10
seconds.
8
Press and release the contant
on button once to stop the
motor.
This calibration may be
repeated at any time as
needed.
Foot pedal calibration
Your motor was shipped with its foot pedal calibrated. You will
want to calibrate your foot pedal if you notice you are not getting
a full 400 degree steering rotation or if a new pedal is installed
on your motor.
To calibrate a new pedal to your motor:
1
Put the motor in the run position.
2
Depress the constant on and a momentary button
simultaneously. Hold down for three seconds. You will notice
the motor turn to the center position and start making a
clicking noise in the head.
3
Push pedal into the forward position (toe down), depress the
momentary button.
4
Move the pedal to the center detent position, depress the
momentary button again.
5
Move the pedal in the back position (heel down) and depress
the momentary button.
The calibration for the foot pedal is now complete and the
clicking will stop. The motor should now steer in accordance
with the pedal movement.
13
GB
a. Needs adjustment to
right
b. Straight ahead
c. Needs adjustment to
left
d. Center calibration dial
a
b
c
d
a
b
a. Tilt pedal to click into
detent
b. Center calibration dial
90-10235R21 502