Motor Power FLEXI PRO, Quick Start Manual

Page: 41 / 56

FLEXI PRO
Quick Start Guide 41
Regeneration Resistor
If the application requires a regeneration (regen) resistor, connect the regen
resistor between terminals B1+ and B2.
Regen Interface (P3) (P5)
FLEXI PRO-1D5, FLEXI
PRO -003
FLEXI PRO -4D5, FLEXI
PRO -006
FLEXI PRO -008, FLEXI
PRO -010
FLEXI PRO -013
Pin Pin Label Function
P3
1 B1+ DC bus +
2 B2 Regen bus -
FLEXI PRO -020, FLEXI
PRO -024 Pin Pin Label Function
P5
1 B2 Regen bus -
2 B1+ DC bus +
Regen and AC Input Voltage are combined on one interface on
FLEXI PRO-1D5 and FLEXI PRO-003, 120/240 VAC.
AC Input
The AC Input interfaces vary among FLEXI PRO 120/240 VAC models.
FLEXI PRO-1D5 and FLEXI PRO-003: One interface ( P3 ) for bus power and
logic power.
FLEXI PRO-4D5 and FLEXI PRO-006: One interface ( P4 ) for bus power and
logic power.
FLEXI PRO-008, FLEXI PRO-010 and FLEXI PRO-013: One interface ( P4 ) for
bus power; one interface ( P5 ) for logic power.
FLEXI PRO-020/024: One interface ( P3 ) for bus power; one interface ( P2 ) for
logic power.
Make the following connections:
1. Connect the AC input voltage ground wire to the PE terminal, located on the
FLEXI PRO front panel. Use an M4 ring or spade terminal.
2. Connect L1, L2 and L3 (for bus power):
If the main voltage is from a single-phase source, connect line and neutral
to L1 and L2.
If the main voltage is from a three-phase source, connect the phases to
L1, L2 and L3.
3. Connect L1C and L2C (for logic power):
If the main voltage is from a single-phase source, connect line and neutral
to L1C and L2C.