Inflator Function
1
1
2
3
4
2
3
4
5
6
7
8
9
10
5
6
7
8
Make sure both switches on the unit are set to the Off (middle) position. Press the
locking tab inward and swing open the lid of power cord storage on the side of the
unit and remove the power cord. Insert the power cord plug into the vehicle’s 12 V
automotive outlet. Make sure the red LED indicator on the plug turns on.
Press the locking tab inward and swing open the lid of inflator hose storage on the
side of the unit and remove the hose.
For inflating vehicle tires, remove the cap from the tire threaded inlet air valve stem
and securely screw the inflator hose connector into the valve stem.
For inflating other objects without the inlet air valve stem, attach desired adaptors to
the hose connector. Insert it inside the air inlet valve of the inflatable object.
Set the Inflator/Jack switch to the inflator position to start the inflator.
Inflate the object to the desired pressure while monitoring the pressure level on the
pressure gauge.
After inflating the object, set the Inflator/Jack switch to the Off (middle) position to
stop the inflator.
Remove the inflator hose from the object, and reattach the cap over the car tire's
threaded inlet valve stem.
Wrap inflator hose into a circle and store the hose in its storage.
Disconnect the power cord from vehicle’s 12 V outlet, wrap the cord into a circle and
store in its storage.
Remove the hex wrench from the accessory storage located on the side of the unit.
Remove the rubber cap over the safety valve on the top of the unit to be able to
access the safety valve hex cap screw.
Insert the hex wrench inside the safety valve hex cap screw and turn the wrench
counter-clockwise to loosen screw.
After jack is lowered, re-tighten the safety valve cap screw and replace the rubber
cap over the safety valve and store the wrench inside the accessory storage.
OFF
OFF
INFLATOR
Allow the jack to lift the vehicle until the wheel(s) are slightly off the ground.
Set the Inflator/Jack switch to Off (middle) position.
After servicing the vehicle, set the jack Up/Down switch to the Down position to
lower the vehicle.
When jack is completely lowered, set the jack Up/Down switch and Inflator/Jack
switch to the Off (middle) position.
Disconnect the power cord from vehicle’s 12 V outlet, wrap the cord into a circle and
store in its storage.
OPERATING THE JACK SAFETY VALVE
In a rare occasion when jack’s ram is stuck at UP position and does not come down when
setting the UP/DOWN switch to DOWN position, perform the following:
6
7
model no. 009-1535-4 | contact us 1-888-942-6686
OPERA
TION
OPR
TA
TION
