Page 8
Attaching the Wheels
Attaching the Wheels
There is a left and a right wheel and it is important that you put them on the correct
side, otherwise the trolley will not move. There is an “L” and “R” on the inside of the
wheel on the central hub. Left and Right sides are determined when stood behind the
trolley at the handle.
NB : DHC trolley models do not have a specific left and right wheel.
To attach the wheels follow these simple steps:
1. Push the quick release button in towards the centre of the wheel
2. Slide the wheel on as far as it will go (onto the inner groove)
3. Once in place, release the button and pull the wheel outwards slightly to lock in place
4. A small click will confirm they are in the correct position
The outer groove can be used as a “free-wheel” option if you run out of battery power.
IMPORTANT : To check you have attached the wheels correctly onto the inner groove,
you will find they only rotate freely in one direction (not applicable to DHC models).
Inverting the Wheels
The wheels can be inverted to reduce the trolley width for transportation and storage.
1. Push and hold the quick release button while sliding the wheel off the axle
2. Flip the wheel over, push and hold the button, then slide onto the axle as far as possible
3. Release the button and pull wheel out slightly until it engages with the free wheel groove
Left
Right
