Page 5
Please Note: The wire should only have power
when the ignition key is turned on.
e. Attach the two bullet connectors to the
corresponding connectors on the winch
contactor/solenoid.
4. BATTERY CONNECTION:
When routing the wires, the appropriate terminals should
be located near the battery, switch, mounting point and
winch. Installation requirements will vary depending on the
winch and vehicle.
Note
: If the wires are not long enough to reach the battery,
switch mounting point, and winch, switch the wires or
increase the length of the wiring harness.
Ensure that the wiring harness does not interfere or come
in contact with any hot or moving engines, suspension,
steering, braking or exhaust parts.
Attach the battery wires and the winch wires to the
contactor locations as shown below.
Note:
Do not connect the battery at this time.
Connect BLUE post to the winch BLUE post
Connect YELLOW post to the winch YELLOW post
Connect RED post to the battery POSITIVE post
Connect BLACK post to the battery NEGATIVE post
For more installation assistance, please call our toll free
line at 866.527.7637 or visit our technical support page at
www.motoallianc.com.
Cable / Rope and Rubber Line Stopper Installation
The first layer around the winch drum should be put on close
and tight. New cables/ropes must be wound onto the drum of
the winch under a load of at least 500lb. Cables/Ropes are
not wound on the winch under load at the time of production.
1. Completely unspool the steel cable / synthetic rope on
the winch and remove from the winch.
