Troubleshooting
22
The j oystick control panel will display a number of possible fault conditions by means of the LED
light. When the LED light is green, the chair is trouble-free. When a problem occurs, the LED light
causes and solutions. If you cannot determine the cause of the trouble condition, please contact
your provider or distributor for assistance.
P ower:
Number
Number
Possible Cause
Possible Cause
Solution
Solution
1
1
2
3
4
5
2
3
Faulty connection of the
control panel and the
motor connector
The lowest level LED light
req uired
The second level LED light
panel failing to deliver
control signals
The third level LED light
being charged.
The fourth level LED light
failed.
the electromagnetic brake
is in “ Unlock” position and
the chair will not move
Re-plug the 4-pin plug into the battery connector at the
side of the chair; refer to instructions on page 15.
If the power is off automatically, the batteries must be
recharged within 2 hours, and charged for 10-12 hours,
refer to instructions on page 22-23.
P ull out the battery and check the contact for any fault and
re-insert the battery. Refer to instructions on page 21-22.
Recharge the batteries immediately.
Reconnect the plugs of the two ends of the control panel
cable, or replace the control panel.
Do not use the chair, an electronic drive locking device
preventing the chair from operating when batteries are
being charged.
Re-plug and tighten the motor connector.
P ush the electromagnetic brake lever to “ Lock” position,
please refer to instructions on page 19.
Low power supply, the
power cuts off
automatically
Fault of the 3-pin plug
connecting to the battery
Summary of Contents for Foldalite Trekker
Page 1: ...Instruction Booklet F ...
Page 28: ......