![background image](http://html1.mh-extra.com/html/eagle-health-supplies/72131/72131_instruction-pamphlet_3284009001.webp)
1.
Take leg
frame
(Part C),
and lay it
flat on
the
ground.
2.
Take the two
short tubes
(Part D), and
insert them
into leg
frame (Part
C). Make sure
the brass
buttons snap
firmly into
the leg frame.
3.
Take the other leg frame (Part
B), and insert the short tubes
into the leg frame. Make sure
the
brass
buttons
snap
firmly
into
the leg
frame.
4.
Set the frame up on its leg tubes. Take
the seat (Part A), and place it on top of
the frame (with the seat clamps lying
on top of the frame). Make sure the
curved side* of the seat is on the same
side as the protruding backrest tubes
(welded under the frame). Firmly snap
the four seat clamps onto the short
tubes of the
frame. The clamps
should fit
between the gray
tube covers.
[* If padded seat,
the non-rounded-
edge side]
5.
Take the 4 legs (Part E), and
insert them into the bottom of
the leg frames. Set the chair
height by using the same
button-hole location for each
leg. Make sure the brass
buttons snap firmly into the leg
frame. For
your safety,
adjust the
rubber tips on
the legs by
turning them
so they make
maximum
floor contact.
6.
Take the backrest (Part F), and press
the two brass push buttons on
the frame of
the backrest.
Insert the
backrest into
the backrest
tubes
underneath
the seat, and
push it in until
the brass
push buttons
snap firmly
into place.