Page 3 (3)
User manual/Assembly instructions - Seat height adapters
Step 4
: Replacement of gas spring holder.
See Figure .
Loosen the nut (
n
) a few turns. Take apart the bolt
connection at the bottom of the gas spring holder and
remove all components (
p
,
q
,
r
, and
s
).
Remove the circlip (
m
) at the wheel frame attachment.
Note:
Be careful that the circlip is not damaged
(opened too far) so that it can be re-used. Remove the
joint pin (
k
). The holder can then be removed by pulling
it down from the gas spring.
The new holder is assembled in the reverse order. Push
the holder up over the gas spring, attach with the joint
pin through the wheel frame. Check that the circlip (
m
)
is properly seated.
The bolt connection is assembled per Figure .
For 50 mm adapters use the lower slot in the holder, for
30 mm adapters user the higher slot (see Figure ).
Do not fully tighten the nuts (
n
) and (
p
). This is done
after adjustment of the seat plate zero position, which
is done on flat ground with the wheels mounted.
For detailed information on adjustment of the seat
plate zero position and the gas spring attachment in
the holder see
Technical Information
sections 2.4, 2.5
and 2.6 (document number 96720-1).
Check the functions of the wheelchair before it is used.
Use and Care instructions
Depending on the user a check should always be done after mounting height adapters to see if there is
an increased tipping risk.
Always replace damaged parts immediately. For more information see
Maintenance Instructions
,
document number 96730-1.
5
5
6
Slot for
50 mm adapters
Slot for
30 mm adapters
6
5
k
m
p q
r
s
n
