Page 2 (3)
User manual/Assembly instructions - Seat height adapters
Step 2
: See Figure .
Check that the correct adapter plate is being assembled.
Set in the bushings (
h
) through the holes in the wheel frame from the
inside. Mount the adapter plate with the screws (
d
) and washers (
e
).
Screw on the nuts (
j
) but do not fully tighten, the adapter plate
needs some flexibility. Mount the adapter plate on the other side.
Step 3
: See Figures , and .
Place the seat frame in place so that the joint bushings (
b
) fit into
the upper holes of the adapter plates.
Assemble the screw (
d
) and washer (
e
), and then the washer (
f
) and
nut (
g
) from the inside. Tighten only by hand.
Repeat these steps on the other side of the wheelchair. The seating
unit is thus secure and a helper is no longer needed.
Tighten all nuts on both sides. Check that the joint bushings (
b
) are
properly seated.
2
2
3
4
4
2
3
b
d
d
h
j
e
e
f
g
