OPERATION
If there is any electrical failure (of the fuse system, ground protection or transformer), turn
off and unplug the unit immediately. Make sure the microscope is set aside so it will not be
used again and contact the Motic service department or a Motic microscope repair agency
to have it repaired.
Please be sure to turn off the power before opening the instrument to replace LED illuminator
or replace the fuse! Only use a fuse for the rated current. Safety instructions for the use of
immersion oil.
• Immersion oil is irritating to skin; avoid contact with skin, eyes and clothing.
• Skin contact: wash with soap and plenty of water until the immersion oil is completely
removed.
• Eye contact: flush immediately with plenty of water for at least 5 minutes. If irritation
persists, seek medical advice.
• Dispose of immersion oil properly. Do not discharge into surface water or sewage.
The biological microscope is not equipped with any special device to protect against corro-
sive, latent infective, toxic, radioactive or other hazardous samples. Therefore, when examin-
ing any such sample you must comply with the relevant laws and regulations, in particular
the provisions related to accident prevention.
QUALITY WARRANTY
The SILVER150 Series biological microscope and the attached accessories are only allowed
to be used for microscope examination as described in this manual. The manufacturer takes
no responsibility for any other use.
• The manufacturer guarantees that the product is free from any defect in material or
workmanship on the date of delivery.
• If any defect is found, notify the manufacturer immediately.
• Upon receipt of the Notification of Defect as described above, the manufacture is responsi-
ble to solve the problem either by repairing the defective instrument or replacing it with a new
instrument of the same model.
• The manufacturer provides no warranty for any failure or defect due to normal wear and
tear or improper use of the product.
• The manufacturer takes no responsibility for any damage caused by operation error,
negligence or unauthorized dismantling of the instrument, or the use of spare parts from
other manufacturers.
SILVER
150
SERIES
| 03
SAFETY INSTRUCTIONS
SILVER
LINE
