9
wipe it clean using lens tissue.
• Close lamp house cover plate and secure until it snaps into
position.
b. LED
1. Unscrew two hexagonal screws retaining the base plate.
2. Unscrew four Allen hex socket cap screws holding back
cover plate.
The printed circuit board is located behind the back cover plate.
3. Disconnect the LED connection cables from the power sup-
ply printed circuit board.
4. Loosen LED board locating ring, take away LED board locat-
ing ring.
5. Install the new LED.
6. Feed LED cable through LED board locating ring.
7. Connect the LED connection cables to the power supply
printed circuit board, then tighten LED board locating ring.
8. Fasten four Allen hex socket cap screws holding back cover plate.
