Mother's Choice serenity 017340, Instruction Manual

Page: 29 / 36

• vv
v
3
PUSH
DOWN
SASH
LAP
PULL
OUT
SLACK
CLICK
SELECT
RECLINE
1, 2, 3
quick start guide
Forwar d-facing installation:
12 months up to 4 years (appr oximately)
• vvv
2
PUSH
DOWN
PULL
OUT
SLACK
CLICK
quick start guide
Rearward-facing installation:
newborn up to 12 approximately
POSITION 4
• vvv
3
PUSH
DOWN
SASH
LAP
PULL
OUT
SLACK
CLICK
SELECT
RECLINE
1, 2, 3
quick start guide
Forward-facing installation:
12 months up to 4 years (approximately)
• vv
v
3
PUSH
DOWN
SASH
LAP
PULL
OUT
SLACK
CLICK
SELECT
RECLINE
1, 2, 3
quick start guide
Forwar d-facing installation:
12 months up to 4 years (appr oximately)
• vvv
28
CLICK!
repeat until
CLEANING BUCKLE:
• Place the buckle unit under running water (40
degrees Celsius), ( Figure 2). Let the water flow
through the mouth of the buckle for one minute.
• Simultaneously latch and unlatch the tongues
into the buckle several times until a strong
audible click is heard (
Figure 2a).
• If you still cannot hear a strong audible click
after latching the buckle several times. Repeat
steps above.
• DO NOT oil any part of the buckle.
• Allow buckle to completely dry.
• If the buckle does not return to original working order, contact Dorel
Australia Customer Service on 1300 809 526.
• If you are a New Zealand customer, please contact IGC Dorel New
Zealand Customer Service on 0800 628 000.
REFITTING BUCKLE:
• Refit crotch buckle ensuring
RED button is
facing out ( Figure 2b).
• Place the two metal plates back through
openings.
• Pull up on each side of the crotch straps
firmly to snap the metal plates back into
place (
Figure 2c).
2
2a
2b
2c
convertible car seat
care and maintenance
• vvv
29
TO REMOVE SEAT TRIM:
1. Loosen the harness by pressing down on centre
front adjuster.
2. Turn seat around and undo shoulder straps from
the splitter plate (
Figure 3).
3. Pull straps through the cover.
4. Undo the buckle and remove the seat trim.
NOTE: ENSURE HARNESS IS NOT TWISTED
Take extra care to be sure the harness is reinstalled correctly and the
shoulder straps are of equal height through both the trim and the harness
slots of the seat.
• Seat trim may be removed for cleaning. Don’t forget to remove the
instruction manual.
• Machine washable on lukewarm setting - delicate cycle.
• Tumble dry 10-15 minutes on low heat.
• Do not dry clean.
• All other surfaces should be cleaned with a mild soap and water.
• Never clean with bleach or spirit-type cleaners.
• Do not use the restraint without the cover.
• Check the webbing for fraying.
SPLITTER
PLATE
3
TO REPLACE SEAT TRIM:
1. Pull the seat trim on the seat.
2. Feed the shoulder straps through the harness slots.
3. Attach the shoulder straps to the splitter plate.
convertible car seat
care and maintenance