Installation/Owner’s Manual Ref IR20200116
For Warranty Service Call 866-359-7378
CLEANING & MAINTENANCE INSTRUCTIONS
1.
Before cleaning, be sure the oven is cool and the power switch is in the off position.
2.
Carefully clean the appliance daily to guarantee its proper operation and long life. Remove the
oven-interior racks and rack slide frames. (The rack slide frames are readily removable by merely
raising to disengage them from their sockets.) Wash the racks and rack slides in a sink with mild
detergent and warm water. Dry them thoroughly with a clean cloth.
3.
Look to see if any foreign matter has accumulated in the blades of the blower wheel, (particles of
aluminum foil is very common of this.) The debris in the blower wheel will reduce the air flow
circulation inside the oven and as a result will be poor bake performance. Use a stiff brush to
remove debris and baked on matter from the blade of the blower wheel. Then wash with soap and
water.
4.
Wash the interior surfaces with mild detergent and warm water. Rinse thoroughly with clean water.
For stubborn/baked on debris a commercial oven cleaner may be used. Do not use steel wool in
the interior of the oven, particles of the steel wool could be left behind and may contaminate food
product. Scotch-Brite® pads or alike that are non-metallic may be used.
MONTHLY CLEANING
•
Clean around the rear of the oven, especially the rear of the motor. Be sure the cooling vents
are not blocked with lint or debris. If so, use a stiff bristle brush to clean.
CLEANING STAINLESS STEEL SURFACES
•
On the stainless front or interiors, deposits of baked on splatter may be removed with any non-toxic
industrial stainless steel cleaner.
•
Apply cleaners when the oven is cold. Always rub with the grain of the metal. Never in a circular
direction.
•
Using Scotch-Brite® pads in combination with powdered cleanser to remove tint and darkened areas.
Always scrub in the direction of the grain of the stainless steel.
11
WHEN CLEANING THE CONVECTION OVEN BLOWER WHEEL, BE SURE THE POWER SWITCH IS IN THE OFF POSITION.
FOR YOUR SAFETY, DISCONNECT THE ELECTRICAL POWER SUPPLY TO THE APPLIANCE BEFORE CLEANING.
