PRO-67-B V.2.S
PLACEMENT OF COAX TO PHASING LINES
< > Locate the pre-drilled hole in the phasing line to the opposite side of the mast plate. The hole is 9 1/2" back from
the BROWN front radiator. This side of the phasing line will receive the center or “HOT” section of the coax. This is
important because it keeps the center of the coax the furthest from ground.
< > Place the #1021 Solder Lug with the "Center of the Coax" on the bottom side of the phasing line. Secure it to the
phasing line with the 8/32 x 1" screw, 3 lock washers and 8/32 nut.
< > (Note: Place a lock washer on the screw first then put the screw through the phasing line. Place another #8 lock
washer on the screw. Now place the #1021 solder lug with the "Center coax lead" onto the screw. Place the last lock
washer and the 8/32 nut on the screw.). (Parts 29, 29b, 29c).
< > Tighten down screw keeping #1021 solder lug and coax lead pointing in over and toward the center of the boom.
< > Once the line is secure tape over the screw and down over the bottom side of the connection. This will protect the
connection from the weather.
< > Repeat the above procedure with the braided side of the coax.
Re-check ALL CONNECTIONS
< > Make sure all hardware is tight and all color codes were followed.
< > Make sure the penatrox was used.
< > Place any remaining end caps or boom caps in place.
< > Check the coax attachment points.
< > Review the drawings with end tip and inner dimensions.
17
