Moser 1590, Operating Instructions Manual

Page: 11 / 74

11
ENGLISH
de
en
fr
it
es
pt
nl
sv
no
fi
tr
pl
cs
sk
hu
sl
ro
bg
ru
uk
el
ar
Cleaning and Care
· Do not immerse the appliance in water!
· After each use, remove the attachment comb and use the cleaning brush to remove cut hairs
from the housing opening and from the blade set. To do this, remove the blade set
(Fig. 5
ⓐ
) and press the cleaning lever (Fig. 6). This allows the cut hairs that accumulate
between the bottom blade and the top blade to be easily removed using the cleaning brush
(EASY CLEANING).
· Only wipe the appliance with a soft cloth, which may be dampened slightly. Do not use sol-
vents or abrasives!
· The blade set can be cleaned with hygienic spray, order no. 4005-7051.
Do not use any other cleaning agents.
· For a long-lasting, good cutting performance, it is important to oil the blade set frequently
(Fig. 7). Use only blade set oil for this purpose, order no. 1854-7935 (200 ml).
· Blade set oil and hygienic spray is available from your dealer or our Service Centre.
· If the cutting performance deteriorates after long use despite regular cleaning and oiling, the
blade set should be replaced.
Changing the blade set
· Switch off the appliance using the on/off switch (Fig. 2
ⓑ
).
· The blade set can be removed by sliding it away from the housing in the direction of the
arrow (Fig. 5
ⓐ
).
· Replace the blade set by hooking it into the housing and pressing it down until it clicks into
position (Fig. 5
ⓑ
).
Disposal in EU countries
Do not dispose of the appliance with domestic refuse. As part of the EU Directive gov-
erning the disposal of electrical and electronic equipment, the appliance is accepted
free of charge by local waste collection points or recycling centres. Discharge batteries
prior to disposal! Correct disposal will ensure environmental protection and prevent
any potentially harmful impacts on people and the environment.
Disposal in non-EU countries
· Please dispose of the appliance at the end of its service life in an environmentally friendly
manner.
· Disconnect the plug-in transformer from the mains power supply and switch on the appliance
to discharge the battery completely.
· Remove the blade set (Fig. 5
ⓐ
) and use a screwdriver to remove the screws in the opening
of the housing (Fig. 8). Exert force to pull the housing parts apart and remove the entire drive
with the PCB (Fig. 9).
· Pull battery off circuit board. If necessary, use a screwdriver to pry them off (Fig. 10).
· Take the batteries to an appropriate collection point.
· Once the batteries have been removed, the appliance may no longer be connected to the
mains!