STARTING - STOPPING THE ENGINE
M
21
REV.0-01/16
Do not alter the primary conditions of regulation and do not
touch the sealed parts.
NOTE
!
Check daily
STARTING THE ENGINE
lnsert the electric protection device (D) lever towards above,
see page M37 –
Introduce the key (Q1), turn it clockwise com-
pletely, leaving it as soon as the engine starts.
Let the engine run for some minutes before drawing the load.
OFF
ON
START
RUNNING-IN
During the first 50 hours of operation, do not use more than
60% of the maximum output power of the unit and check the
oil level frequently, in any case please stick to the rules given
in the engine use manual.
CAUTION
!
If the engine fails to start, do not insist for at least 15
seconds.
Space the further operations waiting for at least 4 mi
-
nutes.
ATTENTION
!
STOPPING THE ENGINE
+
Before stopping the engine
it is compulsory
to effect the
following operations:
- stop to draw three/single-phase current from the auxiliary
sockets
OFF
ON
START
- stop to draw power from the welding sockets.
Make sure that the unit is not supplying any power.
Disconnect the electrical protection device (D) lever downward.
Stop the engine turning the key (Q1) it counter
clockwise, OFF position, then take it out.
+
NB.:
for safety reason the key must be kept by qualified
personel.
07/01/16 C0ME801
1_01-16_EN
