Once the Keyfobs have had the control permissions set the
receiver
board will need to learn the new addresses of the Keyfobs.
1. Press the learn button on the receiver board.
2. With the LED light flashing on the board press the up
and down buttons on the keyfob.
3. Press the button on the receiver board again to turn
off the LED light and test your Keyfobs new signal.
[Do this process seperately for both remotes and test both
after you have finished. If your remote does not work
or only one button works, go back to setting the
transmitter address and repeat the process over.]
MODE_IND window indicating that the
new signal is being initialized.
3. Once the button is released, the randomized address
is saved and the LED light will begin flashing
indicating that the Control Permission may now be
set.
4. Press the CREATE_ADDR button with a paperclip
again or wait 17 seconds for it to time out. The address
and Control Permission are now set. The decoder will
need to learn the address before it will accept any
transmissions.
How to Sync the Receiver Board with the Remotes
Summary of Contents for Ultimate 1000 Lift ML-013P
Page 1: ...Manual Operation Maintenance Models ML 013P ML 014W ...
Page 16: ......
