16
To reduce the risk of breaking the glass, avoid striking the glass or slamming the door.
2. Unscrew the 4 bolts that secure the glass. (In the event that a bolt sheers off when being
unscrewed, remove the remaining body of the bolt by drilling down its centre with 1/8 inch high
speed steel drill bit. Smaller drill bits may be successful, but do not use a lager bit. Make sure
the bit stays away from the edges of the bolt - this may damage the thread in the cast iron).
3. Remove the old ceramic gaskets and clean up the surface underneath with wire wool or
emery paper to remove loose particles.
4. Place the new gasket material in position around the perimeter of the window area, making sure
to pinch them to the length in such a way that they make a continuous seal. Leave no gaps.
5. Place the new glass in position on the strips and screw home the fresh bolts and fitting by
hand.
6. Finally, give each of the bolts an extra half turn or so. The glass should held tight enough by
that cleaning will not dislodge it. Do not over-tighten the bolts as this may put excessive pressure
on the glass, resulting in cracking - important!
1. When you open the door, you will find two hinge pins, one in each hinge. Remove the two
hinge pins, lift the door off the hinges and place it face down on a sheet of cardboard or other
nonabrasive fabric.
NOTE: The flame-path equipment, the ceramic rope and the paint finish are not covered
by guarantee.
All of these service parts can be bought from your morsø dealer, and we recommend that
damaged parts are replaced as soon as possible to avoid collateral damage.
Should the baffle be distorted by an overfire, the stove will still function, although its efficiency
may be compromised. Replace it as soon as possible.
Reasons for fast internal wear and tear
Persistent heavy firing
Soot and ashes left to accumulate
Internal service parts
The flame-path equipment - consisting of the ashpan, grate, firebricks, Cast iron fire plates, glass,
baffle and flue collar - are subject to the extremes of heat produced by the fire. From time to
time, one or other of these parts may need replacing as a matter of routine maintenance.
Gasket
The gasket around the perimeter of the door may harden over a period of time. It should be
replaced if it becomes difficult to close the doors or if air starts to leak in around the perimeter
of the doors, causing the fire to become a little less controllable. A morsø rope gasket kit is
available from your stove supplier.
Summary of Contents for 7670
Page 7: ...7 ...
Page 24: ...24 Morsø jernstøberi A S 09 03 2012 72761600 ...
