FCC and Industry Canada Information to User
This device complies with Part 15 of the FCC Rules and with Industry
Canada license-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas
produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
REMOTE
FCC ID: 2ANLC-OMQ22817
IC: 23130-OMQ22817
MODULE
FCC ID: 2ANLC-HJL71117
IC: 23130-HJL71117
NOTE:
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Replacing the Batteries in the Remote
STEP 1
To install the two CR2032 batteries in the remote, use a small flat screwdriver to separate the two
halves of the remote by prying apart the internal clip locations.
STEP 2
Stack the batteries positive to negative inside the rear cover with the positive end pointed in the
direction of the circuit board. Take note of “NEG” on the case and “+” symbol on the circuit board.
STEP 3
Snap the front cover/circuit board onto the rear cover.
Internal clips
Positive
Negative