19
1. Open lid and ignite the desired burners per “Lighting Instruction” section.
2. Close lid and preheat grill on “HIGH”.
3. Wear protective gloves and use long handle tongs to place food onto cooking grids above the un-lit burners.
4. Adjust controls to desired flame height.
5. With lid closed, cook until desired internal food temperatures are achieved.
6. Turn grill “OFF” per “Turning off” instruction.
For more tips on direct cooking please see “Tips for Better Cookouts and Longer Grill Life”.
Operating Side Burner
NOTE:
Side burner can be used while main burners are operating.
Never
use side burner as a grill.
CAUTION: DO NOT
lean on the side burner shelf.
IMPORTANT:
Never light or use the side burner with the lid in the closed position.
Lighting Instructions
1. Open the lid. Attempting to light the burner with lid closed may cause an explosion!
2. Make sure there are no obstructions of airflow to the burners. Spiders and insects can nest within and clog the
burner / tube at the orifice. A clogged burner tube can lead to a fire beneath the appliance.
3. Control knob must be in the “OFF” position. (Figure 3)
4. Connect gas cylinder per “Installing Gas Cylinder” section.
5. To turn regulator ON, turn the regulator valve handle counterclockwise to the “ON” position (Figure D).
CAUTION: If you are unable to turn the regulator handle to the "ON" position, your regulator is not properly
connected.
DO NOT force the handle to open. Remove the regulator and repeat "Connect Gas Cylinder" section.
6. Push and turn control knob counterclockwise to (HIGH) to light the burner. Repeat up to 3 times if the burner cannot
be ignited successfully.
7. If ignition does not occur within 5 seconds, turn the burner control knob to “OFF”, wait 5 minutes, and repeat lighting
procedure.
8. If ignition does not light burner, use a lit match secured with the lighting rod provided to light burners manually.
Position the lit match near side of the burner. (Figure 6)
Important:
Always use the lighting rod provided when lighting burners with a match.
9. After lighting, observe the burner flame, make sure all burner ports are lit and flame height matches illustration.
CAUTION:
If burner flame goes out during operation, immediately turn the control knob to “OFF” position, turn the gas
cylinder valve to “CLOSED” and open lid to let the gas clear for 5 minutes before re-lighting.
Turning off
1. Turn gas cylinder valve to “CLOSED”.
2. Turn all control knobs clockwise to the “OFF” position.
Note: A “poof” sound is normal as the last of the Propane gas is burned
3. Disconnect gas cylinder per “Disconnect Gas Cylinder” instructions.
Figure 6