Do not remove the water tank immediately after the unit stops. Please wait a while to
avoid the water dripping into the unit and causing damage.
Only empty the water tank when it is full or before moving or storing the unit.
Do not rest the tank on the floor because the bottom of the tank could be uneven and
tank may fall and cause the water to spill.
When you remove the tank, do not touch sensors or any parts which are situated
behind tank. Doing so may damage the product. Be sure to push the tank gently all the
way into the unit. Banging the bucket against anything or failing to push it securely into
place may cause the unit not to operate.
Do not remove or damage the float switch in the water-tank, otherwise the machine will
stop working.
Please make sure the water tank cover is put back into place correctly before the water
tank is reinserted.
If the water-tank is inserted incorrectly, the tank full indicator will flash. Remove the
water tank and reinsert to turn the indicator off and resume normal use.
At all times, avoid water entering the unit. It may cause an electrical hazard and
damage the unit.
NOTES:
This dehumidifier has a continuous drain hole that can be connected to a plastic pipe with a
15 mm inner diameter (Not Supplied). Water can be smart plumbed in or drained into a sink,
a larger receptacle or through the wall into an outside drain. Please follow the steps below to
set your unit up for continuous drainage.
Set up continuous drainage (Select configuration)
Cut off the cover for the continuous drain on the back of the unit.
Pull out the water tank and connect a water tube of inner diameter 15mm to the drain
connector, and ensure the connection is tight * Please note, the water tube is not
supplied with the unit.
Return the water tank back into position within the unit.
1.
2.
3.
This unit uses gravity fall to dispose water hence the drain should be lower than the
dehumidifier water outlet. Be sure to run the water pipe downward and let the water flow out
smoothly. Do not kink or bend the pipe.
NOTE: When the continuous drain feature is not being used, reverse the pipe installation, to
start the water collecting in the water tank.
The permanent drain can be used in conjunction with a water pump (e.g. when draining from
a cellar) to lift the water upwards.
Always shut off the unit and unplug it from the mains before cleaning or performing any
maintenance. When it is not in use for long periods, it is advisable to remove the plug from the
power socket. Do not use chemical solvents (such as benzene, alcohol or gasoline) as they
may cause irreversible damage to the unit.
Filter Cleaning
The Air-inlet may gather dust easily, please clean it often with a soft, damp cloth. If the
filter is covered by dust, the airflow and the performance of the unit will be affected, it may
even cause damage to the unit. We recommend that you regularly clean the filters. The
dehumidifier must be disconnected from the socket before maintenance and the filters must
be allowed to fully dry before re use.
CARE AND MAINTENANCE
Remove the filters from the unit, and tap the dust away.
Clean the carbon
filter
and the mesh filter with a vacuum cleaner or soft-brush.
If dirt and grease is accumulated wash the mesh filter in hot soapy water.
Replace the filters in position as shown in the diagram.
1.
2.
3.
4.
Note: Never use the unit without the antibacterial mesh dust filter. The active carbon
filter should be replaced if necessary after
3-6 months
of usage.
16
17
