Before use
Unwind and straighten the power cable
(9)
and vapour spray
cord
(12)
.
For first use, follow the ‘Quick Start Guide’ on page 3.
NOTE: When you have plugged in your Vapocare iron,
press the precision temperature control
(4)
once to turn the
product on.
NOTE: For first use, you will need to hold the precision
vapour trigger
(2)
for up to one minute before water vapour
is produced from the vapour nozzle
(1)
. It is normal for the
product to make a loud noise during this process.
Textiles and clothes should carry ironing instructions. If not,
follow the temperature guide above, but test the temperature
by ironing the hem of the garment or similar discreet area
first. It is advised to begin with ‘cool’ fabrics and work up to
higher settings. An iron heats up quicker than it cools down
so you’ll save time and electricity.
If you turn the temperature down from a hot setting to a
cooler setting, wait until the temperature indicator lights
(15)
have stopped flashing before you continue ironing.
NOTE: Hold the base with both hands when handling,
moving and storing the unit.
Filling
Neverusebatterytoppingupfluidorwatercontaining
anysubstanceslikestarch,sugar,fragrantadditivesor
defrostedwaterfromarefrigerator.
Unlikeconventionalirons,theVapocareironisdesigned
forusewithtapwater.
Re-filling during use
7
:
If you press the precision vapour trigger (2), and the water
level is low, the vapour nozzle (1) will flash, a beep will be
heard, and the unit will not produce vapour. If this happens,
remove the water tank (6) and refill with water (see steps
1 and 2 of ‘Quick Start Guide’ on page 3) and replace the
water tank.
NOTE: You can still use your product without vapour.
Features
Dryironing:
To use your Vapocare iron as a dry iron only, follow steps 3,
4 and 6 of ‘Quick Start Guide’. You do not need to put water
in the tank (6).
Auto shut-off
8
:
If the Vapocare iron is not used for 10 minutes, the product
will automatically enter standby mode, both for safety and to
save energy.
Wake the product by pressing either the precision
temperature control (4) or the precision vapour trigger which
will illuminate the power light (11). The previous temperature
setting will be restored.
Please wait until the temperature indicator lights (15) stop
flashing before resuming ironing.
Emptying and storing
9
When you have finished Ironing, press and hold the precision
temperature control (4) for three seconds to switch the
Vapocare iron into standby.
Unplug and empty all water from the water tank and place
the iron on the base (14). Use the power cable storage hole
(10) to keep the power cable (9) tidy.
NOTE: Do not store the vapour spray cord (12) in the power
cable storage (10), this is for the storage of the power cable
(9) only.
10
Maintenance
TocleantheThermoglasssoleplate:
Wait until cold and use a damp cloth and mild detergent to
wipe over, then wipe dry. Do not spray detergent directly
onto the soleplate.
ToremovefibresfromtheThermoglasssoleplate:
If any man-made fibres fuse to the Thermoglass soleplate (3),
set the iron to the 3-dot or MAX position and pass it over a
clean piece of cotton to draw the deposit off the surface.
Tocleantheexterior:
Allow the unit to cool and wipe over with a damp cloth and
mild detergent, then wipe dry.
g
f
d
p
i
q
≈
}
∂
t
