2.
Twist connector 1800, until it is in place.
(Fig F)
The fit between the connector and the
tubes and/or handle is tight to ensure no
steam leaks. It is recommended to keep
both parts lubricated to facilitate connecting
and disconnecting.
To detach the accessories, press the
release button (16) and pull the items apart.
Please note accessory heads may be hot!
Please be careful not to trap your fingers.
OPERATING YOUR STEAM CLEANER
Connect the unit to the mains and switch
on the boiler heater by pressing the on-off
button (2). The ‘heater on’ light is illuminated.
Steam will be available in approx. 10 minutes.
When the steam is ready for use the
‘steam ready’ light (6) will turn green.
Make sure that the locking mechanism
(14) on the handle has been released.
If you push the lock (14) towards the rear,
the steam switch can not be operated.
Push the lock forward so that the steam
switch is released. (Fig G)
To make steam ready press the ‘steam
on/off’ button (3) and the orange light (8)
will come on. STEAM IS NOW READY TO
BE RELEASED.
To release steam, press the handle
control switch (13). At the start, always
point the steam handle at a cloth until a
steady flow of steam comes out.
During steam release the green light will
turn off.
To stop releasing steam, simply release
the handle control switch (13).
If your steamer features a varisteam knob
(17) the steam flow can be adjusted to
specific requirements.
Turn the varisteam knob fully anticlockwise
for maximum steam and clockwise for
minimum steam flow. (Fig H)
If the ‘refill’ indicator light (7) turns red,
the boiler must be refilled.
SETTING UP YOUR STEAM CLEANER
Filling the boiler
Unscrew the filler cap (1) anti clockwise
Fill the boiler with a maximum of 1.8
litres of water by using the funnel (19)
provided (Fig A)
Do not use any detergents.
Screw the filler cap (1) clockwise until
finger tight. Do not over tighten.
Attaching Hose and Accessories
Pull down flap on the front of the
machine socket.
Insert the plug on the end of the hose (11)
into the machine socket (4) with button
side facing up, and push firmly until it
clicks into place. (Fig B)
Attach the desired accessory,
i.e. large
floor brush (20), triangular nozzle (27), jet
nozzle (22), window cleaner (26),
to the
extension tube (15) or directly to the
handle (12), depending on the application.
The accessories vary per machine
The round brush(es) (23 & 24) can be
attached to the jet nozzle.
To join the extension tubes together, slide
one tube into the other until it locks into
place. (Fig C)
Attach the two tubes to the handle of
the hose. Slide the handle into the
extension tube until it locks into place.
(Fig D).
Some tasks may be easier with only one tube
fitted or none at all.
To connect the desired accessory directly
to the steam handle, slide the handle into
the accessory head until it locks into place.
When using the large floor brush (20) or
the triangular brush (27), the brush
connector (21) needs to be fitted to the
brush first, in order to attach the same to
the extension tube.
To fit the connector:
1.
Push the connector end, holding it upside
down, fully into the brush inlet. (Fig E)
A
C
D
E
F
G
H
B
12
13
14
17
4
5
