5
NOTE: Before initial use, please charge
your floor sweeper overnight (16 hours).
NOTE: Charging should not be carried
out when the ambient temperature is below
0˚C or above +40˚C. The charger will
become warm during use. This is perfectly
normal.
Using
Note: Remove cloth support pad
when using on carpets
1
Switch charger off at the wall socket.
2
Disconnect the charger from the
floorhead.
3
Remove cloth support pad, unless using
sweeper with hard floor cloth.
4
Place the sweeper on the surface to be
cleaned and press the on/off pedal with
your foot.
5
With one foot placed gently on the rear
of the sweeper pull the handle back to
the desired use position
Brush stall
If the brush is stalled the indicator
illuminates red and the motor stops. To
reset switch off, remove the cause of the
stall, wait 30 seconds then switch back
on.
Cleaning hardwood
and laminate floors
Note: Cloth support pad should be
fitted for use with hard floor
cleaning cloths only.
1
Turn the sweeper over to access the
underside.
2
Attach cloth support pad.
3
Lift open the cleaning cloth clip Insert a
cleaning cloth then press the clip down
to secure it into place.
Note: The cloth may be dampened slightly if
required.
4
Turn the product right side up and attach
corners of cleaning cloth by pushing
them into cleaning cloth grippers
5
Re-fit dust container
6 Use as described previously. The cloth
supplied is disposible. Replacement
cloths can be purchased using the
helpline. Alternatively standard large
floor wipes availabe from most major
supermarkets can be used.
DO NOT USE PRODUCTS CONTAINING
BLEACH
70475 rev4 3/3/06 11:49 AM Page 5
