Locating the filter
1
To remove the filter, slide the locking tab
on the removable filter holder to the
unlock position and and lift both the
holder and mesh filter out to clean. (see
cleaning)
2
To refit, place the removable filter holder
into the top of your coffee maker, making
sure the tab lines up with the rib then
slide the locking tab to the lock position.
Place the permanent mesh filter inside
the filter holder by lining up the locating
tab with the groove in the filter holder as
shown.
Making a perfect
espresso coffee
1
Unscrew the pressure cap
È
by turning
it anti-clockwise.
2
To fill the water tank
Í
use your glass
jug
Û
to measure the volume of water
required. The jug is marked with the
water levels for 2 cups (minimum), 4
cups and 6 cups (maximum).
Always switch the machine off and
remove the plug from the socket before
filling the water tank. Care should be
taken to ensure that the correct quantity
of water is placed in the tank, as the
machine always uses all the water.
3
Close the pressure cap tightly by turning
it clockwise.
4
Place the washable metal filter
Ï
into
the filter holder
Ó
and add the desired
quantity of coffee to the filter using the
measuring spoon provided. Special
marks on the inside of the filter show the
correct levels for 2, 4 and 6 cups of
coffee. Using the flat end of the spoon
lightly compress the coffee down.
Remove excess coffee from the edge of
the filter.
5
Position the filter holder underneath the
water outlet
Ò
, push it upwards and turn
it to the right into the locked position to
fix it onto your coffee machine.
Note : Push firmly to the right to lock
into position.
6
Your machine is fitted with a strength
selector
Î
which allows you to make
LIGHT to STRONG coffee. Set the
strength selector mid way between
LIGHT and STRONG for MEDIUM
strength coffee.
7
Place your glass jug with the lid on the
drip tray
Ô
and
directly under the
spout of the filter holder, ensuring that
the jug handle is pointing outwards from
the unit. Press the on/off switch
Ú
to
‘ON’ and the orange light will glow. The
coffee will start to flow from the filter
holder spout after about 2 or 3 minutes.
Wait until all the water from the water
tank has flowed into your glass jug and
the green light glows.
8
Set the on/off switch to ‘OFF’.
9
When the filtering process is complete
remove the glass jug from your coffee
maker and pour the coffee into your
cups.
Note: Due to the amount of steam lost
through the process, the coffee produced
will be less than the water put in. This
accounted for in the amount to put in.
Locking
tab
Rib
6
47004 Rev 1 22/7/03 5:39 pm Page 7
