E
D
44
FFoorr AAddvviiccee,, SSppaarreess oorr AAcccceessssoorriieess,, tteell::
00884455 007777 77770000 ((UUKK))
oorr
11880000 440099 111199 ((IIrreellaanndd))
Quick accessory
assembly guide
B
Please refer to the accessory
assembly section for full
descriptions on how to attach
tubes and nozzles.
Most accessories are stored in the
cart under the steamer
C
.
Using
IMPORTANT: Please remember
that the steam cleaner operates by
emitting steam at an increased
temperature of 120°C. Never use it
on objects or surfaces which
cannot resist this temperature,
delicate materials, dralon, plastic,
natural fur etc. Where any doubt
exists check carefully on a part of
the material where minor marks
will not matter.
Filling the boiler
D
Ensure the steamer is unplugged
from the mains supply before
filling or re-filling.
1
Unscrew the filler cap
›
by
pressing down and turning anti-
clockwise.
2
Fill the boiler with a maximum of
1.0 litres of water by using the jug
and funnel provided. Warm water
may be used which will reduce the
heat-up time. Do not use any
detergent.
3
Refit the filler cap and fully tighten
by pressing down and turning
clockwise.
Warning: The filler cap must
never be opened during use.
IMPORTANT: The use of any other
fluids can be dangerous and can
lead to damage of the heating
element.
Switching on
1
Insert the plug into the power
socket.
2
Switch the cleaner on by pressing
the on/off switch
fl
to ‘on’
E
. The
red power indicator light
‡
and
the orange thermostat indicator
light
·
will illuminate. It will take
approximately seven minutes to
reach the correct temperature.
3
When the correct temperature has
been reached the orange
thermostat indicator light will go
out. The steam cleaner is now
ready to use.
The orange thermostat indicator
light will cycle on-and-off during
operation to show that the
steamer is maintaining the correct
temperature.
Warning: To avoid injury, the
cleaner should be switched
off during breaks or pauses of
work. For extra safety apply
the trigger safety lock.
If you leave the working area,
please switch the cleaner off and
unplug.
Re-filling the boiler
Warning: Always switch off,
unplug from the mains supply
and release all steam before
opening and removing the
filler cap.
1
Release the steam pressure by
pressing the steam trigger
Ê
on
the handle until all the steam has
been expelled
F
. Leave the
steamer to cool down for a few
minutes.
2
Fill the boiler as previously.
•
Use warm water to reduce the risk
of spitting.
C
B
F
70536 rev1 version2 7/9/07 14:42 Page 4
